AVerMedia LX5000 User’s Manual

Click Camera Setup. It will show a window like the following:

You can select the Camera based on the serial number, and do the proper adjustment for each camera: The adjustment includes turning off the camera signal, display the camera, camera name, picture adjustment, and PTZ camera setting.

1.Camera no

Click on the desired camera button to configure the further setup. Check Disable to disable the camera if it isn’t desired to be shown on the screen or has no signal.

39

AVerMedia LX5000 User’s Manual

2.Camera name

Name a specified camera in Camera name field

3.Disable camera

Turn off Signal: To decide you want to monitor the camera or not is fully depended on this camera is selected or not. Because the system will set all the cameras at the display status automatically. Therefore, when you did not use the entire camera, please turn off those unused cameras. This can avoid the picture quality to be affected. This can also reduce the numbers of display and recording. After you select it, the camera will show gray level condition in the monitor screen.

4.Display Check this item to allow camera screen to work.

5.Image Properties

You may set the following properties for the image of this camera: brightness, saturation, hue, contrast

Settings for the image properties are configured for the designated card, which may also connect to other cameras. That means, the settings you make for this camera will apply to other cameras that connect to the same card.

The adjustment of image properties will result in inefficiency as the video format is set to be PAL for the unsupported

hardware temporarily

40