AVerMedia LX5000 User’s Manual

Direction buttons

Use these buttons to navigate the camera’s directional focus during surveillance.

PTZ Camera Number

You may view the status of each PTZ camera by clicking on the corresponding PTZ Camera Number buttons. Highlighted cameras indicate that the PTZ cameras are connected. The gray (disabled) squares indicate that no PTZ cameras are operational or no cameras are installed.

2. PTZ Setup Menu

Preset Position Number

 

Move Speed Rotation Speed

 

 

 

Zoom in / Zoom out

 

Clear

 

 

 

 

Focus in / Focus out

Up / Down / Left / Right

Stay Time

Save

 

 

Select one of the 16 preset positions from the Preset Position Number buttons, then select the speed from one of the 4 Speed buttons (the higher the level, the faster the speed), and then use the Up/Down/Left/Right buttons to adjust the position of the camera.

/ Focus in / Focus out: Click these buttons to adjust the image focus.

/ Zoom in / Zoom out: Click these buttons to zoom in and zoom out, enlarging and reducing the image respectively.

75

AVerMedia LX5000 User’s Manual

Stay Time: Use this setting to configure the stay-time in seconds (1~8 seconds), which defines the time the camera stays fixed at its previous or next preset position, depending on your PTZ model, during Auto Pan.

Rotation Speed: This parameter defines the speed the camera rotates from the current position to its next preset position. The rotation speed (degree/second) ranges from 30°per second to 240°per second in increments of 30°per second.

Save: After completing the steps above, click this button to save the current preset position settings. Choose the next preset position and follow the same steps until all desired positions are set. If you

want to continue with another camera, click to go back to the main menu of the PTZ Camera and select the new camera.

Clear: Click this button to clear the previous settings for all preset positions for the current PTZ camera. If you only want to delete some of the preset positions, you need to click into each preset position, delete and/or reset new parameters before you click the Save button.

4.3.5 Start Network Service

Press this button: start or stop the internet service. Then, it can accept the Client to do the remote management through the web viewer and remote management program. When you press the button one more time, you can stop the internet faction. The system will ask you to input the password when you log on or log off. When the system

76