User Manual Model 676 LOKPRINT® Printer Unpacking / Installation •
••
• 9
AC Power Line
AVERY DENNISON requires that the electric service be 10 Amps @ 115VAC or 10
Amps @ 230VAC. This will allow the computer and any additional support or
service equipment to be plugged into the same service.
Any electrical service which is supplying a AVERY DENNISON printer or
peripheral equipment connected to a AVERY DENNISON printer should follow
standard electrical code practices including proper grounding and neutral
requirements.
The AVERY DENNISON printer was designed to operate in an industrial setting for
extended periods of time; however, the printer is controlled by a microprocessor
which is very sensitive to brownouts or power spikes. For this reason as well as the
minimum recommended current supply, AVERY DENNISON recommends that a
separate “clean” service be installed or reserved for the exclusive use of the AVERY
DENNISON printer and it’s peripherals.
Printer Unpacking / Installation Unpacking
The AVERY DENNISON printer is shipped in a large cardboard box that may be
difficult to move by hand.
DO NOT REMOVE THE PRINTER FROM THE PACKAGE OR UNPACK
IN THE SHIPPING / RECEIVING DEPARTMENT.
NOTE: Unpacking in the shipping / receiving department is not recommended for
the following reasons.
First: The box in which your AVERY DENNISON printer was shipped allows the
printer to be moved with a forklift, forkcart or handcart. Because of the
weight of the printer, it is easier and safer to use one of these devices to
move the printer to its intended installation location.
Second: Leaving the printer in the crate while it is being moved within your
facility will help to protect the printer during the movements to this new
location. Once the printer has reached its intended location you should
begin the unpacking process.
Open the box from top by removing the two (2) banding straps and cutting the tape
seam on top of the printer. (See Figure 3).
Remove the plastic over the printer.
Remove all the smaller loss items from in and around the printer.
There is a sleeve to lift the printer from the box for easy removal.
Lift the printer onto the table.