Avery ALS 330/430 manual Display and data input, Dispenser active on

Operators Manual

ALS 330/430

4.4.3Display and data input

The operator panel controls the operation of the machine. Data can be displayed and changed. The displays have different meanings:

yParameter selection:

In the display a parameter is shown, e.g. POS, STAD, or PD02 (product menu no. 02). By pressing the keys FUNCTION another parameter can be selected. By pressing the key ENTER the data is displayed.

yData display:

The display shows the values of the parameters (e.g. 0123) or possible adjustments e.g. (AUTO). Pressing the FUNCTION keys changes the data value. By pressing the key ENTER the data input is completed and a new parameter is shown.

yError display:

If the display shows e.g. E__XX, the dispenser has recognised an error. A warning is shown by W_XX. As soon as the error has been corrected, you may erase the message by pressing the key ENTER and you will get back to the status the machine was in before the error was indicated.

Note: Data entered in the standard menu are not stored, if the machine is switched off. If you need to store data you have to use the extended menu. Please check if it is of help for you using the product menu in your application.

Display	Menu function	Function data value
ON	Labeller ready
OFF	Label function suspend
POS	label position on product	Up to 999.9 mm
STOD	Label stop position at the	Depends on setting of DIST, Label
	dispensing edge	length and RAMP
VELO	Dispensing speed	ALS 330: 0.2 ... 25.0 m/min
		ALS 430: 0.2 ... 18.0 m/min
STAD	delay time before labelling starts	0,1 ... 999,9 ms
BLOW	apply time	0,1 ... 999,9 ms
INIT	Initialisation of label material	Appears after E__0, E__1 and Power
	(CONT and LPIT are measured	on + FEED key depressed, or if the
	according to label size)	values of CONT and LPIT are
		changed

Dispenser active ___________________________________________________ ON

The dispenser is able to dispense labels.

Release 4/06 Page 31 Operation