Operators Manual
ALS 330/430
Additional functions in the standard menu
Depending on which parameter has been defined under APPL different menu functions are shown in the standard menu. If an applicator is used additional times BLOW and STAD for controlling the applicator cycling are available.
Input and sensor check____________________________________________ I_CH
To display the status of sensor’s and inputs information are grouped in 3 blocks you can select by pressing the NEXT or PRIOR keys. The character for the inactive state is different to identify the various blocks.
Block 1 (inactive = 0) |
|
N = | Power fail detection (only can case of malfunction) |
P = | Product sensor active |
A = | Signal from APSF sensor |
R = | Ready input stepper motor control |
Block 2 (inactive = |
|
I = Inhibit input active | |
L = | Unused input (Loop control on ALX 720) |
H = | Applicator home switch active |
E = | Applicator end switch active |
Z = | Horizontal home switch |
Block 3 (inactive = .) |
|
S = | pressure switch activated |
J = | Jumper 3 closed |
O = | OD control material active |
M = | Label sensor on material |
G = | Label sensor on gap |
For a correct label sensor information CONT has to be adjusted before. Leave the function by pressing key ENTER.
Output check ___________________________________________________ O_CH
With the NEXT and PRIOR keys you can select the output you will switch on for testing. Leave the function by pressing key ENTER.
On selecting the O_CH function the display shows "1" and the first output is active. Using the
1 = terminal 15 = BLOWON
2 = terminal 16 = AIRSTREAM
3 = terminal 17 = CYLINDER
4= terminal 18 = PRINT_OUT
5= terminal 19 = WARNING
6= terminal 20 = ERROR
Release 4/06 | Page 47 | Configuration menu |
