Bang & Olufsen HDR 2 manual Play a recording, Select a recording

14

Play a recording

In playback situations, the hard disc recorder behaves exactly like a video tape recorder.

If you switch on the hard disc recorder and wait a few seconds, playback of stored recordings begins automatically. If you switch it on from standby, the hard disc recorder takes up to 35 seconds to start up. During this time, you can use the menu system, but not play recordings.

Browse through your stored recordings in an on-screen menu.

Unless otherwise instructed, the hard disc recorder plays the selected recording through to the end. The recording is then paused.

Select a recording

When you select a recording to play, the hard disc recorder automatically resumes playback from where you left off the last time the same recording was played. If you have viewed the recording to its end, playback starts from the beginning.

Select a recording …

>Press V MEM* then the green button to bring up the hard disc recorder’s main menu.

>Press GO to bring up the HARD DISC CONTENT menu.

>Press or to highlight the recording you wish to play. A at the bottom of the list or a at the top of the list indicates that more recordings are available

>Press GO to play the selected recording. Playback information – the time elapsed and the total length of the recording – appears briefly on the screen.

Playback information can be brought up at any time during playback by pressing GO. To remove playback information, press EXIT or wait three seconds.

			HARD DISC CONTENT
THE SOPRANOS				12:14	17 JUN		01:34
CROCODILE		HUNTER		9:12	17	JUN	1:00
WRC RALLY				12:00	14	JUN	1:12
AUSTRALIAN			OPEN	9:00	13	JUN	3:25
SAT	117			23:00	29	MAY	2:55
TV	24			18:00	24	MAY	1:05
V.AUX 4				23:10	22 MAY		12:30
DAYS OF THUNDER				22:00	20 MAY		1:55
CASABLANCA				21:00	13 APR		2:15
							delete
	protection on						play	GO

The HARD DISC CONTENT menu can be brought up during playback by pressing and holding GO. The bar at the top indicates how full the hard disc is. A red dot indicates if a recording is protected. For further information about protection, refer to ‘Edit recordings’ on page 18.

For automatic playback of recordings …

Press V MEM* to switch on the hard disc recorder. Playback of the last recording viewed begins automatically from where you left off. However, other recordings may be played back instead:

–If you have made timed recordings since the last time you viewed a recording, the newest timed recording is played from the beginning;

–If a timed recording is in progress, it is played from the beginning. This does not interrupt the recording process!

*NOTE! On some Beo4 remote controls, the V MEM button is called V TAPE.