Barco 9200 owner manual Change Password, How to enable or disable the password function ?

Service Mode

Change Password

This item is password protected when the password strap is installed.

How to enable or disable the password function ?	Loosen the locking
	screws.
The password function is enabled when the password strap on the
controller module is installed.

To get acces to the controller module, handle as follows :

	0 I		This device complies with Part 15 of the FCC rules. Operation
			is subject to following two conditions :
			(1) This device may not cause harmful interference
			(2) This device must accept any interference received
			including interference that may cause undesired operation
			PROJECTORMODE :	DIAGNOSTICS IR-RECEIVER
- Power down the projector and disconnect the power cord from the	RS232 OUT	RS 232 IN	(800-PERIPHERALS) REMOTE
			GREEN - OPERATION	CODE
			COMMUNICATION PORT RED - STANDBY
wall outlet.				IR-RECEIVED
- Turn both lock screws of the front top cover with a screwdriver
or coin counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly
and lay it down on the second part of the top cover.
	Open the top cover

0 I

	PROJECTORMODE :
	GREEN - OPERATION	DIAGNOSTICS
COMMUNICATION PORT	RED - STANDBY	IR-ACKNOWLEDGED CODE	IR-RECEIVER

RS232 OUT RS 232 IN (800-PERIPHERALS) REMOTE

IR-RECEIVED

R

G

B

H

V

R

G

B

H / C

V

R

G

B

H / C

V

9827910

On

When the strap is on leg 2-3 or no strap is mounted, the password function is enabled, when the strap is on leg 1-2, the password function is disabled.

Password enabled	Password disabled
strap on leg 2-3	strap on leg 1-2

5975947 BARCOGRAPHICS 9200 120297 11-3