Barco 9200 owner manual Connections, Power mains cord connection, Fuses, Switching on

Connections

5CONNECTIONS

Power (mains) cord connection

Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector at the front of the projector.

The power input is auto-ranging from 200 to 240 VAC. This projector may be connected to an IT-power system.

Fuses

Warning

For continued protection against fire hazard :

-refer replacement to qualified service personnel

-ask to replace with the same type of fuse. Fuse type : T12.5 AH/250V

0 I

PROJECTOR MODE:

GREEN - OPERATION

DIAGNOSTICS

RS 232 IN

COMMUNICATION PORT

RED - STANDBY

IR-ACKNOWLEDGED CODE

IR-RECEIVER

RS232 OUT

(800-PERIPHERALS)

REMOTE

IR-RECEIVED

R

G

B

H

V

R

G

B

H / C

V

R

G

B

H / C

V

27910

On

98

0

I

RS 232 IN

RS232 OUT

COMMUNICATIONPORT

(800-PERIPHERALS)

Switching on

Use the power switch to switch on.

When '0' is visible, the projector is switched off. When '1' is visible, the projector is switched on.

When switching on with the power switch, the projector starts in the stand by mode. The projector mode indication lamp is red.

To start image projection :

a. press the 'Stand by' button on the local keypad or on the remote control. The projector mode indication lamp will be green.

b. press a digit button to select an input source. The projector mode indication lamp will be green.

0 I
					PROJECTOR MODE:
				GREEN - OPERATION			DIAGNOSTICS
RS232 OUT	RS 232 IN		COMMUNICATION PORT		RED - STANDBY		IR-ACKNOWLEDGED CODE	IR-RECEIVER
			(800-PERIPHERALS)	REMOTE
							IR-RECEIVED
	R G B H		V	R	G	B	H/ C V
		Projector mode indication

Stand by button

ADJ								EXIT
STBY			TEXT
			-			+
			-				+
9	0
			SHARPNESS
			-	+
7		8
					TINT
			-	+
5	6
				COLOR
		4	-	+
3
			BRIGHTNESS

1 2 - +

CONTRAST

5975967 BARCOGRAPHICS 9200 221297 5-1