Source numbers 81 | Barco 9200 specification

Source Numbers 90 - 99

Source numbers 81 - 84

Only valid if no input module is connected to slot 81 - 84 of a RCVDS05.

The source numbers 81 - 84 correspond to the physical inputs 1 - 4 of the projector. e.g. When slot 1 of the projector has to be selected, key in source number 81.

The relationship between the sources of slot 1 - 4 of the projector with 800 peripheral is shown in the table below.

source of slot 1 source of slot 2 source of slot 3 source of slot 4

source number 81 source number 82 source number 83 source number 84

C-2		5975947 BARCOGRAPHICS 9200 030798

Image 52

Barco 9200 owner manual Source numbers 81

Contents

Graphics Page Barco Projection Systems Date Rev Art. No 030798 R5975947 Federal communication commission FCC statement Table of Contents 10-1 10-210-4 11-1 Projector dimensions Unpacking and DimensionsUnpacking Battery installation in the RCU Installation Guidelines Where to install the projector? How to install a projection lens?RGB Analog with Standard Sync Sync on Green or RGB Analog with TRI-LEVEL Sync Sync on Green or Control Front Panel Terminology Remote control RC operating indication lights up when a button onControl disc Key on RCU or + and keys cursor Local keypad Actual selected configuration will be highlighted InstallationConfiguration Front/table, front/ceiling, rear/table and rear/ceiling Installation Set Up Power mains cord connection Switching onConnections Fuses Switching to stand-by Switching offLamp Run Time Input connections Video/S-video input module 269,2VIDEO,1387 RGB Analog Input Module Component Input Module 2032117B-Y S9,2,1387 RGB3S/RG3sB Input Module Set up of the baud rate for communication with a computer See Change Baudrate PC in chapter Service mode Connecting a VS05 to the projector Connecting a Rcvds 05 to the projectorConnecting an IR Remote Receiver 800 to the projector How to Use the RCU? ControllingProjector Address Point the front of the RCU to the reflective screen surface How to Program an Address into the RCU? How to Display a Projector Address?Picture Controls with Direct Access Start UP of the Adjustment Mode Adjustment Mode Start up of the Adjustment Mode Starting up the Random Access Adjustment Mode Random Access Adjustment ModeFile Service File Service Load FileEdit File Edit file adaptation menu will be displayed How to find the correct values for the displayed item? Example for clamp position trailing Rename CopyRename Copy Delete Picture TuningFile Options Color Temperature Sync slow/fastStill Video Comparison with the green color value Gamma GeometryShift Size Side Keystone BlankingSide Keystone Blanking Options Starting up the Installation Mode Input Slots Convergence Convergence RED on Green Configuration Internal Patterns Service Mode Starting up the Service ModeService Barcographics 9200 11-1 Identification Identification Change Password How to enable or disable the password function ? How to change the password ? Change LanguageChange Projector Address Change Baudrate PC Reset Lamp Runtime Lamp PowerLamp Run Time History Barcographics 9200 11-5 Panel Adjustments Preset Input BalanceHz Tracking I2C diagnosis Standard Source SET UP Files KHz MHz XGA72 1024 768 71,955 58,140 80,000 1376 808 640 X 74,996 68,846 57,280 832 918 870832 X 74,550 49,722 57,280 1152 667 624 640 X 55,370 24,370 21,060 864 440 400 Lens Cleaning Procedure Focusing the lensLenses Lenses Projector without any 800 peripheral connected Projector with a 800 peripheral connected Source numbers 81 13873525&8-6285&6&725