Powering Up the Ripc | Belkin F1DE101G specification

INSTALLATION

Powering Up the RIPC

1.Connect the included power supply unit into an available power outlet.

2.Attach the barrel plug into the power jack located on the rear of the RIPC to the power unit.

Serial 02

power

consoleCPU/KVM

Serial 01

reset

LAN

3.Turn on your KVM Switch. If you do not have a KVM Switch, please proceed with powering up your computers.

10

Image 12

Belkin F1DE101G user manual Powering Up the Ripc

Contents

OmniView Table of Contents Package Contents Introduction Feature Overview Equipment Requirements Hardware RequirementsSoftware Requirements Specifications Ripc Diagrams Connection LEDLink/Activity LED Serial 02 Port LAN Port Installation Hardware Installation Serial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Remote Access Video settingsSync Configuration via serial Prerequisites Following interfaces are supported Log Into the Ripc For a secure connection, you must enter Main Screen Control Host Remote Access Log Out from the Ripc Port by sending the appropriate hot key to the KVM switch Monitor mode is currently activeAuto Adjust Control Description Options Remote Access Options Power Management UnitRipc Mouse Synchronization Sync Detect Single Direct Mouse Mode Badly Adjusted PictureLimitations of the Mouse Synchronization Special Mouse Driver Video Settings Ports & Protocols Force HttpsHttps Port Http Port IP access control parameters Firewall Certificate Management SSL Certificate Request Certificate Request Required Information See Figure below Settings & Configuration Network SSL Certificate Signing Request Network Settings Menu Remote Access Settings Remote Access Options Table Users & Passwords Description Users & Passwords Table Add UserDelete User Modify User Modem Settings Serial Port Settings TableSerial Port Modem Options Table Keyboard/Mouse Settings Keyboard/Mouse Options Table KVM Switches Firmware Syntax to define a new hot key is as follows Update Firmware Ripc Video Modes Hot Key Table Tilde Glossary Does the Ripc work with non-Belkin KVM switches? What operating systems does the Ripc support?Does the Ripc put any strain on the servers? Login fails Remote Access window can’t connect to the RipcRemote mouse doesn’t work or is not synchronous Video quality is bad or the picture is grainy Belkin Corporation Limited Five-Year Product Warranty FCC StatementCE Declaration of Conformity P74238-A