Connecting the Ripc to the Network | Belkin F1DE101G guide

INSTALLATION

Initial Network Configuration

7.Under Setting & Configurations, click on “Network”. (Note: Uncheck “DHCP” check box.)

8.Enter the desired network settings and click on “Apply Changes” to save new network settings.

9.Reset the local IP address settings on the computer used for configuration of the RIPC.

Connecting the RIPC to the Network

Connect the RIPC to the network using a straight-through RJ45 Category 5 network cable.

12

Image 14

Belkin F1DE101G user manual Connecting the Ripc to the Network

Contents

OmniView Table of Contents Package Contents Introduction Feature Overview Software Requirements Equipment RequirementsHardware Requirements Specifications Link/Activity LED Ripc DiagramsConnection LED Serial 02 Port LAN Port Installation Hardware Installation Serial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Sync Remote AccessVideo settings Configuration via serial Prerequisites Following interfaces are supported Log Into the Ripc For a secure connection, you must enter Main Screen Control Host Remote Access Log Out from the Ripc Auto Adjust Port by sending the appropriate hot key to the KVM switchMonitor mode is currently active Control Description Options Ripc Mouse Synchronization Remote Access OptionsPower Management Unit Sync Detect Limitations of the Mouse Synchronization Single Direct Mouse ModeBadly Adjusted Picture Special Mouse Driver Video Settings Https Port Ports & ProtocolsForce Https Http Port IP access control parameters Firewall Certificate Management SSL Certificate Request Certificate Request Required Information See Figure below Settings & Configuration Network SSL Certificate Signing Request Network Settings Menu Remote Access Settings Remote Access Options Table Users & Passwords Delete User Description Users & Passwords TableAdd User Modify User Serial Port Modem SettingsSerial Port Settings Table Modem Options Table Keyboard/Mouse Settings Keyboard/Mouse Options Table KVM Switches Firmware Syntax to define a new hot key is as follows Update Firmware Ripc Video Modes Hot Key Table Tilde Glossary Does the Ripc put any strain on the servers? Does the Ripc work with non-Belkin KVM switches?What operating systems does the Ripc support? Remote mouse doesn’t work or is not synchronous Login failsRemote Access window can’t connect to the Ripc Video quality is bad or the picture is grainy CE Declaration of Conformity Belkin Corporation Limited Five-Year Product WarrantyFCC Statement P74238-A