Users & Passwords | Belkin F1DE101G specification

NETWORK SETTINGS MENU

Users & Passwords

Upon delivery, each RIPC is pre-configured with a supervisor user called “administrator” having the password “belkin”. IMPORTANT: Be sure to change the administrator-user password immediately after you have installed and initially accessed your RIPC.

User & Passwords Panel

The Figure above shows the User & Passwords panel of the RIPC’s front end. Its use will be described in the table below and in the following text.

30

Image 32

Belkin F1DE101G user manual Users & Passwords

Contents

OmniView Table of Contents Package Contents Introduction Feature Overview Software Requirements Equipment RequirementsHardware Requirements Specifications Ripc Diagrams Connection LEDLink/Activity LED Serial 02 Port LAN Port Installation Hardware Installation Serial Power Reset Connecting the Computer or KVM USB Powering Up the Ripc Initial Network Configuration Connecting the Ripc to the Network Sync Remote AccessVideo settings Configuration via serial Prerequisites Following interfaces are supported Log Into the Ripc For a secure connection, you must enter Main Screen Control Host Remote Access Log Out from the Ripc Port by sending the appropriate hot key to the KVM switch Monitor mode is currently activeAuto Adjust Control Description Options Remote Access Options Power Management UnitRipc Mouse Synchronization Sync Detect Single Direct Mouse Mode Badly Adjusted PictureLimitations of the Mouse Synchronization Special Mouse Driver Video Settings Ports & Protocols Force HttpsHttps Port Http Port IP access control parameters Firewall Certificate Management SSL Certificate Request Certificate Request Required Information See Figure below Settings & Configuration Network SSL Certificate Signing Request Network Settings Menu Remote Access Settings Remote Access Options Table Users & Passwords Description Users & Passwords Table Add UserDelete User Modify User Serial Port Modem SettingsSerial Port Settings Table Modem Options Table Keyboard/Mouse Settings Keyboard/Mouse Options Table KVM Switches Firmware Syntax to define a new hot key is as follows Update Firmware Ripc Video Modes Hot Key Table Tilde Glossary Does the Ripc put any strain on the servers? Does the Ripc work with non-Belkin KVM switches?What operating systems does the Ripc support? Login fails Remote Access window can’t connect to the RipcRemote mouse doesn’t work or is not synchronous Video quality is bad or the picture is grainy CE Declaration of Conformity Belkin Corporation Limited Five-Year Product WarrantyFCC Statement P74238-A