General functions
75
The control panel opens. If a
CD is in the drive, it is ejected.
If you do not remove this CD, it
is automatically pulled in again
after approx. 10 seconds.
Insert the CD with its print-
ed side uppermost into the CD
drive C until you feel some re-
sistance.
The CD is automatically drawn
in and the control panel clos-
es. This CD can now be select-
ed as audio source.
Note:
As long as the CD is in the
drive, the device stores track
and playing time of the CD
played last, and after calling up
the audio source, the playback
starts at the position where it
was interrupted.
Inserting an MMC/SD card
Note:
Blaupunkt cannot guarantee
the correct functioning of all
MMC/SD card available on the
market and, for this reason,
recommends the use of MMC/
SD cards manufactured by
"SanDisk" or "Panasonic". The
cards must be formatted using
the FAT16 or FAT32 fi le system
and contain MP3 or WMA fi les.
➔
Remove the control panel as
described on page 9.
Insert the MMC/SD card in the
card slot D until it engages.
The contacts of the card must
point down and to the rear.
Attach the control panel as de-
scribed on page 9.
This MMC/SD card can now be
selected as audio source.
To remove the MMC/SD card:
Remove the control panel as
described on page 9.
Push on the MMC/SD card un-
til it disengages.
Pull the MMC/SD card out of
the card slot D.
Connecting the USB medium
To be able to connect a USB stick
or a USB 2.0 hard disk, the sup-
plied USB cable must be con-
nected to the rear side of the de-
vice before the installation as
described in the installation in-
structions. This cable can be rout-
ed, for example, to the glove com-
partment or a suitable place of
the center console.
Note:
Always switch off the device be-
fore connecting or disconnecting
the USB medium.
➔
➔
➔
➔
➔
➔
02_BA_Memphis_EU_eng.indd AllgFkt7502_BA_Memphis_EU_eng.indd AllgFkt75 03.05.2006 10:44:01 Uhr03.05.2006 10:44:01 Uhr