Connecting a VCR

Connect the incoming antenna or cable	Back of TV
TV signal to the ANT IN jack on the
back of the VCR.
Using a coaxial cable, connect to the
OUT jack on the back of the VCR and
to the TUNER jack on the back of the
TV.
Using A/V cables, connect from the
AUDIO and VIDEO OUT jacks on the
back of the VCR to the corresponding
AV2 audio (L and R) and video (V)
jacks on the back of the TV.

C
2
SERVICE 1
					DVI
	G S-VIDEO
AV1	R	L	V	AV6
AV1				AV6	3
	Pr	Pb	Y
MON	OUT	L	V
					R	L

					R	L
AV2	R	L	V
AV2
				AV5
SUB OUT					RGB+HV
SUB OUT
AV3	R	L	STANDARD/		Pr	Pb	Y
			STANDARD/
			HD INPUTS				TUNER
							TUNER
AV4			STANDARD/		Pr	Pb	Y
			STANDARD/
	R	L	HD INPUTS
	R	L

Incoming Cable TV or Antenna Signal

4 Press the Source Select button on the remote control to access the Source list.

5 Press the Cursor Up or Down button to select the AV2 input source.

6 Press the OK button to confirm your choice. The set is now switched to the AV2 input source for the viewing of pro- grams from the VCR.

NOTE: Since you’ve connected the cable TV signal directly to the TV’s tuner (step 2 above), you can watch the unscrambled programs by simply tun- ing to the desired channel. To store channels in the TV’s memory, you must use Autoprogram, which you can access through “Install” in the TV’s on-screen menu. See the Autoprogram section in the Quick Use and Setup Guide that came with the TV. If you use Autoprogram, you can select chan- nels by pressing the CH + or – buttons on the TV remote control (in TV mode). Otherwise, you must press the digit (number) buttons to tune directly to the channel you desire.