Bose PDF259774_00 manual Connecting the Wave/PC unit to your computer

System Setup

Connecting the Wave/PC™ unit to your computer

This step tells you how to connect the Wave/PC unit to your computer using the cable sup- plied with your Wave/PC system. Illustrations of the two most typical computer connection panels are provided (Figure 6 and Figure 7). Refer to the figure that best represents your com- puter and the following steps.

Note: If you are using stereo speakers with your computer, disconnect them before continu- ing with this procedure.

1.Turn your computer off.

2.Insert the DIN connector of the Wave/PC system cable into the DIN socket on the rear panel of the Wave/PC unit (Figure 6 or Figure 7).

3.Connect the serial data port (DB-9) connector of the Wave/PC system cable to the serial (RS232) data port of your computer (Figure 6 or Figure 7).

4.Connect the audio plug (3.5 mm) of the Wave/PC system cable to the audio output jack of your computer (Figure 6 or Figure 7).

CAUTION: Do not connect the Wave/PC unit to an AC (mains) outlet until after connecting your Wave/PC unit to your PC.

Figure 6

Example 1: Wave/PC sys- tem connections

Serial data port

Serial data port (DB9) connector

Audio plug

Rear panel of computer

DIN socket

Audio

output

jack

DIN connector

Wave/PC system cable

10 April 12, 2001 PDF259774_00