System Setup

Figure 7

Example 2: Wave/PCsystem connections

Audio plug

Serial data port

Serial data port (DB9) connector

Rear panel of computer

 

Audio

DIN socket

output

 

jack

 

DIN connector

Wave/PC system cable

Connecting the power cord to the Wave/PC unit

1.Plug the small end of the power cord into the power jack on the back of your Wave/PC unit (Figure 8). The connector is shaped to fit in only one direction. Line up the flat edge of the plug with the flat edge on the side of the jack.

2.Connect the other end of the power cord to an AC (mains) outlet. The clock time display should begin flashing. The flashing will stop during software installation when the clock is set by your computer.

Figure 8

Connecting the power cord

PDF259774_00

April 12, 2001

11

Page 11
Image 11
Bose PDF259774_00 manual Connecting the power cord to the Wave/PC unit