BOXLIGHT 12SF manual The LED on the top of the projector on page 30 lights green

S e t t i n g u p t h e P r o j e c t o r

5Plug the power cord into the side of the projector, then plug it into your electrical outlet. A surge-protected power strip is recommended.

•The LED on the top of the projector (Figure 24 on page 30) lights green.

Now you are ready to turn on the equipment and watch HDTV.

6Remove the projector’s lens cap.

7Turn on the lamp by pressing the green power button on the keypad or remote.

•A tone sounds when you press the button, and the LED blinks green while the software initializes. When initializa- tion is complete, the LED lights solid green and the startup screen appears.

8Turn on your HDTV tuner.

•The HDTV image should display on the projection screen. If it doesn’t, press the source button on the keypad or the video button on the remote to display your HDTV image. You can select a default source to determine which source the projector examines first during power-up for active video; see “Default Source” on page 45.

•If necessary, adjust the zoom or focus of the image by turn- ing the rings around the lens. See page 27.

•If you are projecting on a 4:3 screen, change the screen aspect to 4:3. See page 35.

•If necessary, make adjustments to the image using the pro- jector’s on-screen menus. To open the menus, press the menu/select button on the keypad or remote, then select the Display or Image sub-menu. For more information about the menus, see page 33. If you want to return to the factory default settings, choose Reset in the Advanced menu.

•If the image is not square, use the keystone buttons on the remote to adjust the image’s shape. See page 31.

•If you connected the audio cables to the projector, use the volume buttons on the keypad to adjust the volume. If you connected the audio cables from your video device to your receiver, use the receiver’s volume control.

20