Breville BBM300 Control Panel Messages, Care, Cleaning and Storage, Error Detection, Spare Parts

Control Panel Messages

Care, Cleaning and Storage

Error Detection

When the ‘Start’ button has been pressed to begin the process and there is a problem relating to the sensor, the machine will ‘beep’ twice and then flash the particular error message specific to the problem.

There are 4 different error messages:

error	problem	correction
message
E:01	If attempting to use the bread machine	Press ‘STOP’ to reset. Open the lid and
	shortly after a loaf has been baked, its	remove the bread pan to cool. Always allow
	interior will still be warm, that is, the sensor	the bread machine sufficient time to cool
	temperature will still be above 40ºC.	before using again.
E:02		Contact your nearest authorised Breville
		Service Centre (refer to the back page for
		details).
E:03		Contact your nearest authorised Breville
		Service Centre (refer to the back page for
		details).
E:04		Contact your nearest authorised Breville
		Service Centre (refer to the back page for
		details).

Before cleaning your bread machine, switch off and then unplug from the power outlet and allow the bread machine to cool completely.

Bread Machine

The inside and outside of the bread machine and the lid should be wiped with a soft, damp cloth then dried thoroughly. If over spills such as flour, nuts, sultanas, etc., occur in the baking chamber, carefully remove, using a damp cloth. Before re- using your bread machine ensure that all parts are completely dry.

NEVER immerse the bread machine or the bread pan in water.

Note

Bread Pan and Kneading Blade

The inside of the bread pan and collapsible kneading blade are coated with a high quality, non-stick coating. As with any non-stick coated surface, NEVER use metal utensils or abrasive cleaners on these items.

To clean the bread pan and blades:

Half fill the bread pan with soapy water (use a non-abrasive detergent), allow to stand for 10-20 minutes. Remove the kneading blade and clean both blade and inside of bread pan using a soft cloth. Be sure to remove any crust or dough that may become lodged around the drive shaft and the kneading blade. Take care not to scratch the non-stick surface on the inside of the bread pan and the kneading blade.

DO NOT USE HARSH CLEANERS, ABRASIVES, BRUSHES OR STEEL WOOL.

NEVER WASH THE BREAD PAN OR KNEADING BLADE IN THE DISHWASHER.

To clean the collapsible blade:

Particular care should be used to clean the hinged area of the collapsible blade. After soaking in warm, soapy water for 10-20 minutes, use a wooden toothpick or thin wooden skewer to remove any bread residue from the hinged area. Failure to clean the hinged area may eventually result in the collapsible blade not working effectively.

Some discolouration may appear on the bread pan over time. This is a natural effect caused by moisture and steam and will not affect the bread in any way.

Note

Storage

When storing the bread machine, switch off and then remove the power plug from the power outlet. Ensure it is completely cool, clean and dry. Place the bread pan and kneading blades into the baking chamber and close the lid. Do not place heavy objects on top of the lid. Store the bread machine upright.

Replacement Bread Pan and Blades

Both the collapsible blade and bread pan coating are operating parts of the machine and as such are subject to normal wear and tear over the life of the machine. Depending on your usage of the bread machine they may need replacement if the bread begins to stick.

Spare Parts

Replacement parts are available from Breville Spare Parts:

Australia Customer Service: 1300 139 798

New Zealand Customer Service: 0800 253 007

24 25