OPERATING your Breville Duo-Temp™ espresso machine

STEP 7 - BREWING THE COFFEE

The red ‘Heating’ light cycles off when the machine has reached the correct temperature for brewing.

Ensure the Drip Tray and Grid are in place.

Place one or two pre-warmed cups beneath the Filter Holder outlet.

NOTE

The machine remains ready for brewing and maintains a constant heating temperature while the Power On/off button is in the ‘On’ position. If the temperature lowers, the heating light will illuminate and the Thermoblock Heating System will automatically reheat to the correct brewing temperature.

STEP 6 - INSERTING THE

FILTER HOLDER

Place the Filter Holder underneath the Brew Head so that the handle is aligned with the insert graphic. Insert the Filter Holder up into the Brew Head and rotate the handle to the right until resistance is felt, this will be at an approximate 90° angle to the machine.

Set the Selector Control to the ‘Espresso’ position.

After a few seconds, aromatic coffee will begin to brew into the cups. A pumping noise will be heard in this operation.

When sufficient coffee has flowed into the cups, set the Selector Control to the ‘Standby’ position. This will stop the flow of coffee.

If the steam function is not required, leave the Selector Control to the ‘Standby’ position, unplug the power cord and allow the machine to cool.

PRE-BREW FUNCTION

When the Selector Control is set to the ‘Espresso’ position, the 15 bar pump pumps water momentarily, followed by a pause, then continues to pump the water through to the ground coffee in the Filter Holder. This prebrew function is an advanced feature of the BES800XL.

The ground coffee is moistened by a small amount of water before full extraction. The ground coffee expands and when greater pressure is built up, the brewed coffee is extracted with its full flavor.

17

Page 18
Image 18
Breville ME 67 manual Brewing the Coffee, Inserting Filter Holder, PRE-BREW Function