care & cleaning
CLEANING THE STEAM WAND AND FROTHING ATTACHMENT
be removed by using the spanner in the middle of the Cleaning Tool.
• The Steam Wand and Frothing |
|
Attachment should always be cleaned |
|
after frothing milk. |
|
• Remove the Frothing Attachment and |
|
rinse in warm tap water. Ensure the two |
|
fine steam holes on either end of the |
|
Frothing Attachment are clear. Use the |
|
pin on the Cleaning Tool to unblock |
|
these holes. |
|
• Wipe the Steam Wand with a damp |
|
cloth, then with the Steam Wand |
|
directed back into the drip tray, briefly |
|
set the Selector Control to the ‘Steam’ |
|
position and press the Hot Water button. |
|
This will clear any remaining milk from | • Soak the tip in hot water before |
inside the Steam Wand. | |
| using the pin on the Cleaning Tool |
| to unblock. Replace the tip back onto |
| the Steam Wand and secure with the |
| Cleaning Tool. |
•Ensure the Selector Control is in the ‘Standby’ position. Press the ‘ON/OFF’ button to ‘OFF’, unplug the power cord and allow the machine to cool.
•If the Steam Wand remains blocked, use the pin on the Cleaning Tool to clear the opening.
•If the Steam Wand continues to be blocked, the tip of the Steam Wand can
25
