Breville ME 67 manual Steam BUTTON/HOT Water Button, Auto Purge Function

OPERATING your Breville Duo-Temp™ espresso machine

STEAM BUTTON/HOT

WATER BUTTON

•The Steam button surround will automatically illuminate when the machine is switched ‘On’ with the Power On/Off button.

•The machine will always automatically default to the Steam button when the appliance is first switched on.

•Both buttons cannot be operated at the same time.

•To select steam: when the Steam button surround is illuminated, just set the Selector Control to ‘Steam’

•To select hot water: press the Hot Water button and the surround will illuminate, then just set the Selector Control to ‘Steam’.

•If the machine remains switched ‘On’, the last button function used (Steam or Hot Water) will stay illuminated.

NOTE

Always ensure that the Frothing Attachment has been firmly pushed onto the Steam Wand and connects with the rubber surround.

For best results use cold fresh milk (low fat milk will froth easier).

Always clean the Steam Wand and Frothing Attachment after every use. Refer to ‘Care and Cleaning’ on page 25.

AUTO PURGE FUNCTION

For brewing more coffee immediately after using the steam function, the BES800XL features an auto-purge function. This ensures that ground coffee will not be burnt by the initial water flow from the thermoblock that could be too hot.

Instead this water is automatically released internally into the Drip Tray ensuring that the internal thermostat is at optimal temperature for extracting coffee. Your coffee will always be extracted at this optimal temperature ensuring only the best flavored coffee is achieved.

WARNING

Do not allow milk to run over the top of the frothing attachment, otherwise it will not function properly.

To avoid splattering of hot milk, do not lift the end of the frothing attachment above the surface of the milk while frothing.

Ensure the selector control is in the ‘standby’ position before removing the frothing jug.

20