256 Fabric OS Administrator’s Guide
53-1001763-02
Zoning configurations
11
to one or more traffic isolation zones, the update may result in
localized disruption to traffic on ports associated with
the traffic isolation zone changes.
Do you want to enable 'USA_cfg' configuration (yes, y, no, n): [no] y
zone config "USA_cfg" is in effect
Updating flash ...

Disabling a zone configuration

When you disable the current zone configuration, the fabric returns to non-zoning mode. All devices
can then access each other or not, depending on the default zone access mode setting.
NOTE
If the default zoning mode is set to All Access and more than 120 devices are connected to the
fabric, you cannot disable the zone configuration because this would enable All Access mode and
cause a large number of requests to the switch. In this situation, set the default zoning mode to No
Access prior to disabling the zone configuration. See “Default zoning mode” on page 252 for
information about setting this mode to No Access.
The following procedure ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this procedure is run, the
transaction on the other switch is automatically aborted. A message displays on the other switches
to indicate that the transaction was aborted.
1. Connect to the switch and log in as admin.
2. Enter the cfgdisable command, using the following syntax:
cfgdisable
3. Enter y at the prompt.
Example
switch:admin> cfgdisable
You are about to disable zoning configuration. This
action will disable any previous zoning configuration enabled.
Do you want to disable zoning configuration? (yes, y, no, n): [no] y

Deleting a zone configuration

1. Connect to the switch and log in as admin.
2. Enter the cfgDelete command, using the following syntax:
cfgdelete "cfgname"
3. Enter the cfgSave command to save the change to the defined configuration.
The cfgSave command ends and commits the current zoning transaction buffer to nonvolatile
memory. If a transaction is open on a different switch in the fabric when this command is run,
the transaction on the other switch is automatically aborted. A message displays on the other
switches to indicate that the transaction was aborted.
Example
switch:admin> cfgdelete "testcfg"
switch:admin> cfgsave
You are about to save the Defined zoning configuration. This
action will only save the changes on the Defined configuration.