3. Installation
3. Installation
CAUTION
Machine installation should only be carried out by a qualified technician.
Contact your Brother dealer or a qualified electrician for any electrical work that may need to be done.
The sewing machine head weights more than 400 kg. The installation should be carried out by two or more people.
Co not connect the power cord until installa tion is complete, otherwise the machine may operate if the foot switch is depressed by mistake, which could result in injury.
Be sure to connect the ground. If the ground connection is not secure, you run the risk of receiving a serious electric shock.
Do not place any objects on top of the top cover, otherwise such objects may fall down onto the machine.
If you need to put something on top of the top cover, place it inside a box or similar to se- cure it so as to stop it from falling down.
Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get into your eyes or onto your skin, otherwise inflammation can result. Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and diarrhoea.
Keep the oil out of the reach of children.
Avoid setting up the sewing machine near sources of strong electrical noise such as
If this precaution is not taken, incorrect ma- chine operation may result.
Hold the machine head with both hands when tilting it back or returning it to its original po- sition. Furthermore, after tilting back the ma- chine head, do not push the face plate side or the pulley side from above, as this could cause the machine head to topple over, which may result in personal injury or damage to the machine.
Note:
¡This sewing machine has a movable machine head and work clamp. Be careful not to place other objects within the moving range of these parts.
¡Supply power directly from a receptacle for the machine's exclusive use.
¡Be sure to power off when installating.
3-1. Installation of the machine table
w
1.Secure the level adjusters q so that the table top re- main level.
2.The table has eight level adjusters. If the table does not sit well, loosen nuts w and turn the level adjusters q to level the table.
Note:
There are eight adjusting points.
To move the machine, turn up adjusters q, and the table can be moved on its machine body casters e.
q
e
3 |
