11. Using the DIP switches
11. Using the DIP switches
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury.
Note:
¡Always be sure to turn the power OFF when changing the settings of the DIP switches.
¡The functions of the DIP switches are subject to changes without notification.
¡If DIP switches
■DIP switch positions
|
| DIP switch D |
DIP switch A | DIP switch B | DIP switch E |
| DIP switch C |
|
■Functions of operation panel DIP switches
¡DIP switch A
No. | Functions when ON | |
|
| |
1 | In automatic, pattern matching and label attachment modes, the work clamp stops momentarily before | |
feeding to the home position. | ||
| ||
|
| |
2 | Low feeding speed (Machine head → Folder) | |
|
| |
3 | Low feeding speed (Folder → Machine head) | |
|
| |
4 | Not available (Should be set to OFF) | |
|
| |
5 | Not available (Should be set to OFF) | |
|
| |
6 | Not available (Should be set to OFF) | |
|
| |
7 | After the power is turned on, three pockets are sewn at 3,000 rpm. | |
|
| |
8 | Machine head operation check, stacker operation check |
■Functions of DIP switches on main circuit board
¡DIP switch B
No. | Functions when ON |
|
|
1 | Mismatches between folder numbers and program numbers are ignored |
|
|
2 | Clamp vertical sensor is ignored |
|
|
3 | Needle racking cylinder sensor is ignored |
|
|
4 | Double cylinder sensor is ignored |
|
|
5 | 24 V/36 V power supply voltage check is ignored |
|
|
6 | Single and double clamp data check is ignored |
|
|
7 | Not available (Should be set to OFF) |
|
|
8 | Not available (Should be set to OFF) |
|
|
36 |
