BT Zenith Flip – Issue 1 – Edition 04 – 08.09.05 – 6861
General information | 81 |
|
|
PABX access code
If you are connecting your BT Zenith Flip to a switchboard/PBX you may need to enter an access code (e.g. 9) in order to get an outside line. So that the switchboard has time to pick up an outside line, you may also need to add a Pause after the access code in numbers stored in the phonebook, see page 82.
Set PABX access code
1.Select Menu and scroll UP/DOWN/LEFT/RIGHT to Handset. Select OK.
2.Scroll UP or DOWN to PABX Access Code and select OK. Set Code is highlighted.
3.Select OK and enter the access code you want. Select Clear to delete any incorrect digits.
4.Select OK to confirm or Back to return to the previous screen without saving the code.
Switch PABX access code on or off
You may want to do this if using a handset with different bases, one of which is connected to a switchboard.
When the code is switched off your handset will not dial the code automatically before each telephone number.
1.Select Menu and scroll UP/DOWN/LEFT/RIGHT to Handset. Select OK.
2.Scroll UP or DOWN to PABX Access Code and select OK then scroll UP or DOWN to highlight On or Off.
4. Select OK to confirm. Then select Back to return to standby.
If you experience any problems, please call the Helpline on 0870 605 8047
