Cabletron Systems 9A100 manual UNI Routes

Switch Administration ATMRouting

4.2.2UNI Routes

Use the add ATMRoute command to create UNI routes. For example, connect an end station adapter (with MAC address 00:11:22:33:44:55) to port A2 of the SmartSwitch 9A100. If the adapter does not support ILMI or its ILMI is incompatible with the SmartSwitch 9A100, you must create a static UNI route between the adapter and port A2 of the SmartSwitch 9A100.

1.Enter the show netprefix command to obtain the netprefix of port A2

SmartSwitch # show netprefix

PortNumber(ALL) : a2

Port# NetPrefix

============================================================================

A2 39:00:00:00:00:00:00:00:00:00:14:59:00

SmartSwitch #

2.Reconfigure the adapter with an ATM address made from the netprefix of port A2 and the adapter’s MAC address: 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00.

3.Use the add ATMRoute command to create a static UNI route that specifies port A2 and the adapter’s new ATM address.

SmartSwitch # add atmroute
PortNumber(A1)	: a2
AtmAddress()	: 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00
PrefixLength(152)	:
Index(0)	:
Type(Internal)	:
Scope(0)	:
MetricsTag(0)	:
SmartSwitch #

4.Enter the show ATMRoute command to check that the UNI route was added.

SmartSwitch # show	atmroute
AddressNumber(ALL)		:
No. Port Route Address		Type Protocol

================================================================================

1	B4	39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:d4:14:41:80	I	MGMT
2	B4	39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:d4:14:41:81	I	MGMT
3	--	39:00:00:00:00:00:00:00:00:00:14:59:00	I	PNNI
4	A2	39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55	I	MGMT
5	--	39:00:00:00:00:00:00:00:00:00:28:e9:80	I	PNNI
6	--	39:00:00:00:00:00:00:00:00:00:28:f5:00	I	PNNI
7	B4	47:00:79:00:00:00:00:00:00:00:00:00:00:00:a0:3e:00:00:01	I	MGMT
8	B2	52:00:00:00:00:00:00:00:00:00:14:51:80	I	MGMT

SmartCell ZX #

The UNI route appears in the table as route number four (No. 4).

Note For UNI routes to work with certain devices, ILMI may also need to be disabled on the SmartSwitch 9A100. Use the set PortConfig command to disable ILMI on the SmartSwitch 9A100 on a per-port basis.

SmartSwitch 9A100 User Guide 4-5