
Using the Console | Switch Installation and Setup |
n• Next, the switch prompts for the information necessary to make the switch accessible through your Ethernet network
USwitch name
UIP address
USubnet mask
s¥ After you enter these parameters and reboot the switch, log off the local console connection. Perform additional configuration steps over your network using a telnet connection.
2p›F Only one console connection is allowed at any time. To reach the SmartSwitch 9A100 through telnet, you must exit the local terminal connection by entering the exit command.
The following is an example of the initial configuration session:
SmartSwitch Version 2.1 (c) Cabletron Inc. password:: admin
The current user is Administrator
Could not find setup file
Running Setup Automatically
SwitchName() : My_9A100
IPAddress(0.0.0.0) : 210.160.77.254
IPNetMask(255.0.0.0) : 255.255.255.0
Confirm(y/n)?:y
Changing IP Address on System. Telnet session (if any) will be lost.
SmartSwitch #
Before continuing to chapter 3, “IP over ATM and LANE,” read the following sections for information about
UUsing the SmartSwitch 9A100 console
UInstalling and getting started with the
2.5USING THE CONSOLE
Use the SmartSwitch 9A100 console interface to configure and manage your switch. The following is a description of the console interface and its operation.
2.5.1Console Commands
2p›F For detailed descriptions of console commands, see the SmartCell