IP Routing | Switch Administration |
Note SmartSwitch 9A100 IP routing performance is inadequate for routing between
VLANs. If you need to create routes between VLANs on your
SmartSwitch 9A100, use a router equipped with an ATM interface. Consult
Cabletron Customer Support for recommended routers.
For example,
•Switch SW1 and the NMS are on an Ethernet network with address 128.205.99.0.
•The IP address of SW1's Ethernet port is 128.205.99.254.
•The IP address of SW1's LANE client is 90.1.1.254.
•The IP address of SW2's LANE client is 90.1.1.33.
•SW2 is not physically connected to the Ethernet network.
•SW2 is connected to SW1 through PNNI, and are both part of the same emulated LAN.
To reach SW2 with the
SmartSwitch # add route |
| |
DestNetIP() : 128.205.99.0 | < address of the Ethernet network to reach | |
GatewayIP() | : 90.1.1.254 | < IP address of SW1's LANE client |
SmartSwitch | # |
|
Switch SW2 can communicate with the NMS on the Ethernet network.
To see the route, enter the show route command on SW2
SmartSwitch | # show route |
|
|
ROUTE NET TABLE |
|
| |
destination | gateway | flags Refcnt Use | Interface |
0.0.0.0 | 0.0.0.0 | 1 | 0 | 0 | zn0 |
90.1.1.0 | 90.1.1.33 | 1 | 0 | 1688 | zn1 |
128.205.99.0 | 90.1.1.254 | 1 | 3 | 5660 | ei0 |
ROUTE HOST TABLE |
|
|
|
destination | gateway | flags Refcnt Use | Interface |
127.0.0.1 127.0.0.1 5 0 0lo0
SmartSwitch #
Note The NMS must contain a route that specifies the Ethernet interface of the Ethernet connected switch as the gateway to the ELAN subnet.
