Cabletron Systems 9A100 manual Use show portconfig to see the change to port A1

PVC Connections Switch Administration

3.Use the set portconfig command to reconfigure a port to use the new values for VPI and VCI. For example, to set up a PVC on port A1 using the new VPI/VCI bit ranges (3/9), enter

SmartSwitch # set portconfig a1
PortAdminStatus(up)	:
IlmiAdminStatus(enable)	:
IlmiAddressRegistration(enable)	:
IlmiConnectivity(enable)	:
SigType(autoConfig)	:
SigRole(other)	:
InterfaceType(private)	:
MaxVpiBits(0)	: 3
MaxVciBits(12)	: 9
MaxSvcVpi(7)	:
MinSvcVci(32)	:
MaxVccs(4096)	:
SmartSwitch #

4.Use show portconfig to see the change to port A1.

SmartSwitch # show portconfig a1

==================================================

Port: A1

--------------------------------------------------

Parameter	Configured	Current
--------------------------------------------------
Sig Type	autoConfig	pnni10
Sig Role	other	symmetric
Interface Type	private	private
Max vpi bits	3	0	<VPI on port A1 can now be any 3-bit number
Max vci bits	9	9	<VCI on port A1 can now be any 9-bit number
Max SVC vpci	7	0
Min SVC vci	32	32
Max Vccs	4096	4096
--------------------------------------------------

Other parameters

--------------------------------------------------

Port Admin	Status	UP
Ilmi Admin Status		Enabled AddressRegistration Connectivity
Oper State		UP
Trans Type		STS-3c
Media Type		MMF (S)
Bandwidth		155 MB
SmartSwitch	#

PVCs can be configured for port A1 using VPI values from 0 to 7 and VCI values from 0 to 511.

Note Do not set the VCI part of the VCCMask to fewer than 5 bits.

Note Do not change the VCCMask for the CPU port (B4).

4-16 SmartSwitch 9A100 User Guide