Installing an HSIM
NOTE |
In Step 11 ensure that the standoffs on the interface module align with the standoff screw holes on the HSIM to prevent bending pins.
11.Secure the HSIM to the standoffs with the two screws saved in Step 6.
12.Reinstall the module in the chassis.
13.Reattach the network cabling to the module.
14.Refer to Chapter 3 for instructions on configuring the
2.3.2Installing an HSIM in a Standalone Hub
To install an HSIM into a standalone hub that supports HSIM technology, perform the following steps:
1.Power down the hub and remove the power cord.
2.Disconnect all cables from the hub. Note the ports to which these cables attach.
Ensure that you remove the power cord and ONLY the screws required to remove the chassis cover. Failure to comply could result in an electric shock hazard.
3.Attach the antistatic wrist strap (refer to the instructions outlined on the antistatic wrist strap package).
4.Remove the hub chassis cover (refer to your specific hub documentation for instructions on removing the hub chassis cover).
5.Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure
6.Remove and save the two standoff screws. See Figure
7.Place the HSIM behind the hub faceplate. See Figure
8.Insert the connector of the HSIM into the HSIM connector pins on the hub.