Cabletron Systems T1 manual DDS Service Interface Configuration, Enter

Chapter 4: Local Management for DDS Service

2.Use the arrow keys to highlight MgrType, and choose the Protocol Manager from PPP, FR PtoMP, FR PtoP, or HDLC using the space bar to toggle the selections.

NOTE

When changing from one protocol to another on a WPIM-T1/DDS that has been operational, save NONE as the protocol before changing to another protocol.

3.Use the arrow keys to highlight DDS Line Mode. Press the SPACE bar to set the DDS Line Mode to DDS-PRIor DDS-CC, then press

ENTER.

4.Use the arrow keys to highlight DDS Tx Clock Source. Press the SPACE bar to set to Loop-Timing, then press ENTER.

5.Use the arrow keys to highlight DDS Loop-back. Press the SPACE bar to set to NONE, then press ENTER.

6.Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “SAVE DONE!” displays and Local Management saves the changes to memory. “REBOOT IN PROGRESS......” displays and the host platform reboots. Re-entry to management is necessary for any further configuration.

4.3.2DDS Service Interface Configuration

The WAN Interface Configuration screen is accessed through the WAN Physical Configuration screen. Access the WAN Interface Configuration screen (Figure 4-2) by using the arrow keys to highlight the WAN INT CONFIG command, then press ENTER. Proceed with the following steps to configure the WAN Interface through Local Management.

1.Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Number by typing the same number found in the Interface field on the WAN Physical Configuration screen into the Interface Number field, then press ENTER.

4-10 WPIM-T1/DDS User’s Guide