Campbell Hausfeld SDM-SIO4 manual Data Error Detection, Appendix A. Ascii Table

	5.2.6 Command 5: Status	5-4
	5.2.7 Command 6: Flush Transmit Buffer	5-5
	5.2.8 Command 7: Activate Command Line	5-5
	5.2.9 Command 8: Poll Tx Buffers for Data	5-5
	5.2.10 Command 9: Flush Converted Data Buffer	5-5
	5.2.11 Command 66: Send Single-Byte Data to Datalogger	5-5
	5.2.12 Command 67: Get Return Code	5-6
	5.2.13 Command 320: Send Data to SDM-SIO4	5-6
	5.2.14 Command 321: Execute Command Line Command	5-6
	5.2.15 Command 1024: Send String to Device	5-8
	5.2.16 Command 1025: Transmit a Byte	5-8
	5.2.17 Command 1026: Serial Port Status	5-8
	5.2.18 Command 1027: ‘Manual’ Handshake Mode	5-10
	5.2.19 Command 2049: Set Communications Parameters	5-10
	5.2.20 Command 2054: Set Up Receive Filter	5-12
	5.2.21 Command 2304: Transmit String and/or Data to Device	5-12
	5.2.22 Command 2305: Transmit Byte(s)	5-14
5.3 SDM-SIO4 Configuration Examples		5-14
	5.3.1 Sensors Where the Datalogger Can Request Data by Sending a Prompt
	or Using a Handshaking Line:	5-16
	5.3.2 Sensors Which Send Data Out Without Prompting	5-18
5.4	Outputting Datalogger Data	5-25
5.5	Flushing the Input and Output Buffers	5-26
5.6	Return Error Codes	5-26

Section 6.	Data Error Detection	6-1
6.1	Error detection with the SDM-SIO4	6-1
6.2	Received Data	6-1
	6.2.1 Example of Using Received Data Filters	6-3
	6.2.2 CR10X Program Example	6-3
6.3	Transmitted Data	6-6
	6.3.1 Example of Using Transmitted Data Filters	6-7
	6.3.2 CR10X Program Example	6-8
	6.3.3 Alternative CR10X Program	6-8

Appendix A. ASCII Table			A-1
Appendix B. Serial Port Data Transfer Modes			B-1
B.1		Baud Rates	B-1
B.2		Stop Bits	B-1
B.3		Data Length	B-1
B.4		Parity Bits	B-2
B.5		Serial Handshake Modes	B-2
Figures
1.	Schematic Diagram of the SDM-SIO4		1-2
Tables
1.	SDM-SIO4 Serial Port Pin Configuration		1-3
2.	Address Settings		2-1
3.	Status LED Error Codes		2-3
4.	Fixed Strings Currently Allocated		3-6

ii