Return page 1 to the top, and then press the [Start] key. (Data for the scanned original has exceeded limits on the size that can be handled by this machine. Automatically adjust settings and try again.)
Cause | Scanning has stopped because the data size of the scanned original exceeds the maximum data size that the machine can handle. |
|
|
Remedy | Try scanning the original again from the first page. If scanning is still not possible, reduce the Sharpness mode setting, and select |
| [Text] for the original type. |
Scanning has stopped because the size of the data for the scanned original exceeds the limit. Scanning may be possible if [Sharpness] is reduced and the type of original is set to [Text].
Cause | Scanning has stopped because the data size of the scanned original exceeds the maximum data size that the machine can handle. |
|
|
Remedy | Reduce the Sharpness mode setting, and select [Text] for the original type. |
|
|
Remove the paper from the output tray.
Cause | Prints from the previous job remain in the output tray. |
|
|
Remedy | Remove the prints remaining in the output tray. Printing automatically resumes. |
|
|
Remove the paper from the booklet tray.
Cause | Prints from the previous job remain in the Booklet tray of the Booklet Finisher. |
|
|
Remedy | Remove the prints remaining in the Booklet tray. Printing automatically resumes. |
| |
Replace the toner cartridge. | |
|
|
|
|
Cause 1 | Printing will not be possible soon because the toner is running low. |
|
|
Cause 2 | Printing is not possible because the toner has run out. |
| Replace the toner cartridge. (See “Replacing the Toner Cartridge,” on p. |
Remedy | |
| |
Place the original on the platen glass. | |
|
|
|
|
Cause | The specified mode requires that the original be placed on the platen glass, but there is no original on the platen glass. |
|
|
Remedy | Place the original on the platen glass. |
|
|
2
Troubleshooting
List of Error Messages |