Installing and Removing the Battery and Card

Load a fully charged Battery Pack LP-E12 into the camera. The camera can use an SD, SDHC, or SDXC memory card (sold separately). UHS-I Speed Class SDHC and SDXC memory cards can also be used. The captured images are recorded onto the card.

Make sure the card’s write-protect switch is set upward to enable writing/erasing.

Installing the Card

Write-protect switch

1 Open the cover.

Slide the lever as shown by the arrows and open the cover.

2 Insert the battery.

Insert the end with the battery contacts.

Insert the battery until it locks in place.

3 Insert the card.

As shown by the illustration, face the card’s label side toward the back of the camera and insert it until it clicks in place.

4 Close the cover.

Press the cover until it snaps shut. When you set the power switch to <1>, the number of possible shots (p.36) will be displayed on the LCD monitor.

32