Chapter 4 Other Functions

■ USB Short Packet Setting

■ Roller Counter

If the scanner does not operate normally when using the USB interface, change this setting to [OFF].

■Tray Position Setting

The document feed tray should be set to fit the number of document sheets to be loaded. (See “Preparing the Document Feed Tray” on p. 3-5.)

0:Up to 500 sheets

1:Up to 300 sheets

2:Up to 100 sheets

■Key Repeat Setting

Selects the panel display method.

ON: The panel display scrolls continuously while a key is pressed.

OFF: The panel display scrolls each time a key is pressed.

Hint

Key repeat is valid in the following situations.

•When using the Job Function

•When selecting each of the functions in the User Mode

■Total Counter

Displays the lifetime total number of document pages fed by the scanner.

Displays the number of document pages fed since roller installation or replacement (pickup, feed, and retard rollers). Make sure to reset this counter when replacing the rollers. (See “Checking and Resetting the Page Counter” on p. 5-7.)

■Imprinter Test

When the optional imprinter is installed, this function executes a test printing of the imprinter. (See “Performing an Imprinter Test” on p. 5-20.)

■Auto power OFF function settings

Set the auto power OFF function.

Select ON to enable the auto power OFF function, and if after 4 hours of inactivity, the power turns OFF automatically.

4-8