Canon EOS 10D instruction manual Recharging the Battery, Connect the power cord, Remove the cover

Recharging the Battery

1

2

Connect the power cord.

•Connect the power cord to the charger.

•Connect the power plug to an AC outlet.

Remove the cover.

•Store the cover in a place where it will not be lost.

•If you remove the battery from the camera, be sure to reattach the cover to protect against short circuit.

< – > mark

Attach the battery.

3 • Align the battery’s top edge with the < – > mark on the charger. While pressing down the battery, slide it in the direction of the arrow.

• To detach the battery, follow the above procedure in reverse.

4

Battery charge	Red lamp
0–50%	Blinks once per
	second
50–75%	Blinks twice per
	second
Over 75%	Blinks three times
	per second
Almost full	Stays on

Recharge the battery.

sWhen the battery is attached to the charger, recharging starts automatically and the red lamp starts blinking.

sA completely exhausted battery takes about 90 minutes to almost fully recharge.

•The blinking frequency of the red lamp indicates the progress of the recharging.

sAfter the battery recharging is almost com- pleted, the red lamp will stop blinking and remain lit. Recharging the battery for another hour will fully recharge the battery.

•After recharging the battery, detach it and unplug the power cord from the power outlet.

22