Troubleshooting

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them.

*Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.

Camera Error Message

Possible Cause

Try This

Printer in use

Images are being printed from

Wait until printing ends. The printer automatically starts

 

the computer

printing the images from the camera after completing the

 

 

current printing.

 

 

 

Printer warming up

The printer is warming up

Wait until warm-up ends. When it is ready, the printer starts

 

 

printing automatically.

 

 

 

No paper

No paper is loaded

Load paper in either the Sheet Feeder or Cassette which you

 

 

have selected with the Paper Feed Switch on the printer, and

 

 

select Continue* in the display on your camera.

Paper error

The Paper Output Tray is

Open it to resume printing. If the Inner Cover is open, close it.

 

closed

 

 

 

 

Paper jam

A paper is jammed in the

Select Stop in the display on your camera to stop printing.

 

printer

Remove the jammed paper, load new paper, and press the

 

 

RESUME/CANCEL button on the printer and retry printing.

 

 

 

Printer cover open

The Top Cover is open

Close the Top Cover on the printer.

 

 

 

No print head

The Print Head is defective or

Install a Print Head according to the Easy Setup Instructions.

 

not installed (The POWER

If the Print Head has already been installed, remove it to check

 

lamp on the printer flashes

for any dirt or debris at its contacts. After cleaning, reinstall the

 

five times.)

Print Head.

 

 

If the error still remains, the Print Head may be defective.

 

 

Contact the Customer Care Center.

 

 

 

Waste tank (ink absorber)

The waste ink absorber is

The printer has a built-in waste ink absorber to hold the ink

full

nearly full

used during print head cleaning. This error message indicates

 

 

that the waste ink absorber is nearly full.

 

 

You can continue printing for a while by selecting Continue* in

 

 

the display on your camera.

 

 

However, because printing is disabled once the waste ink

 

 

absorber becomes completely full, you are recommended to

 

 

contact the Customer Care Center as early as possible.

 

 

 

Ink is low

It is about time to replace the

Select Continue* in the display on your camera to resume

 

ink tank with a new one

printing.

 

 

 

Ink tank is empty

Replace the ink tank with a

Printing resumes once the Top Cover is closed after ink tank

 

new one

replacement.

 

 

You can continue printing by selecting Continue* in the display

 

 

on your camera with the ink tank empty. But, it is recommended

 

 

you replace it with a new one immediately after printing. It may

 

 

damage the printer if you continue printing with empty ink

 

 

tanks.

 

 

 

Printer error

An error requiring servicing

Select Stop in the display on your camera to stop printing.

 

might have occurred (the

Disconnect the cable between the printer and the camera, turn

 

POWER lamp on the printer

off the printer, and unplug the power cord of the printer from

 

flashes alternately orange

the power supply. After a while, plug the power cord of the

 

and green).

printer back in, turn on the printer, and then reconnect the

 

 

camera to the printer.

 

 

If the same error occurs, contact the Customer Care Center.

 

 

 

*To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue.

80

Page 84
Image 84
Canon iP5000 quick start Cannot Print Properly from the Digital Camera