3. Projecting an Image (Basic Operation)
This section describes how to turn on the projector and to project a picture onto the screen.
❶Turning on the Projector
NOTE:
•The projector has two power switches: a main power switch and a POWER button.
•When plugging in or unplugging the supplied power cord, make sure that the main power switch is pushed to the off () po- sition. Failure to do so may cause damage to the projector.
1.To turn on the main power to the projector, press the Main Power switch to the on position ( I ).
•The POWER indicator will light orange.
See the Power Indicator section on page 60 for more details.
2. Remove the lens cap.
WARNING 
LAMP 
-
3. Press the POWER button on the projector cabinet or |
WARNING
POWER INFO.
the POWER button on the remote control for about 1 |
second. |
The POWER indicator will turn to green and the projec- tor will become ready to use.
After you turn on your projector, ensure that the com- puter or video source is turned on and that your lens cap is removed.
NOTE: If you turn on the projector immediately after the lamp is turned off or when the temperature is high, the fans runs without displaying an image for some time and then the projector will dis- play the image.
PO | W |
|
|
|
ER | IN | IMAGE | INPUT AUTO PC | |
|
| AUT | ASPECT | NO SHOW |
|
|
| MENU |
|
LAMP 
Standby | Blinking | Power On |
WARNING | WARNING | WARNING |
LAMP | LAMP | LAMP |
S te a d y o r- | Blinking | Steady |
ange light | green light | green light |
See page 60 for more details.
CAUTION:
The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indica- tor is blinking green. Doing so could cause premature lamp failure.
23
