Canon LV-7265 Introduction Battery Installation, Operating Range for Wireless Remote Control

1. Introduction

Battery Installation

1Press fi rmly and slide the battery cover off.

2Remove both old batteries and install new ones (AAA). Ensure that you have the batteries' po- larity (+/–) aligned correctly.

3Slip the cover back over the bat- teries until it snaps into place. Do not mix different types of batter- ies or new and old batteries.

Remote Control Precautions

•Handle the remote control carefully.

•If the remote control gets wet, wipe it dry immediately.

•Avoid excessive heat and humidity.

•Do not heat, take apart, or throw batteries into fi re.

•Ensure that you have the batteries' polarity (+/-) aligned correctly.

•If you will not be using the remote control for a long time, remove the batteries.

•Do not place the batteries upside down.

•Do not use new and old batteries together, or use different types of batteries together.

•Dispose of used batteries according to your local regulations.

Operating Range for Wireless Remote Control

Horizontal range
Remote sensor on projector cabinet
7m/22 feet
	30°
30°	30°
30°
Remote control	7m/22 feet

Vertical range

Remote sensor on projector cabinet

7m/22 feet	7m/22 feet
30°	30°
30°
	30°

Remote control

NOTE: The LV-7260 and LV-X7 do not have the remote sensor on the rear panel.

•The infrared signal operates by line-of-sight up to a distance of about 7 m (22 feet) and within a 60-degree angle of the remote sensor on the projector cabinet.

•The projector will not respond if there are objects between the remote control and the sensor, or if strong light falls on the sensor. Weak batteries will also prevent the remote control from properly operating the projector.

10