Turn on the projector.

Maintenance

■Replacing the Lamp

1 Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour.

2 As shown in the figure, insert a flat- head screwdriver in the gap and remove the lamp cover by raising it.

3 Loosen two screws with a philips-head screwdriver and then pull up the han- dle.

*Pull up the handle as shown in the figure.

4 Remove the lamp while holding the center of the handle.

5 Fully insert a new lamp and secure it with two screws.

*After the installation, be sure to push down the handle.

6 As shown in the figure, replace the lamp cover. Check whether the lamp cover is installed securely.

7

8 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter]. (P103)

9 Select [Reset] -> [OK] to reset the lamp counter.

134