Selecting an Input Signal (INPUT)
■Selecting an Input Signal1 Press the INPUT button to pop up a window shown at the lower right.
Remote control |
|
| Top control | SX80 | SX800 | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The currently active input signal is marked with a circle and highlighted in orange. An input signal that is ready for projection is displayed in white. When no signal is received, it is displayed in gray.
In SX80, [HDMI], [DIGITAL PC], and [ANALOG
When you select [USB] with no PictBridge enabled equipment or an USB flash memory connected and pressing the OK button, a window waiting for you to connect a Pict- Bridge enabled equipment or an USB flash memory appears. For more details, refer to "Projecting an Image from a Digital Camera (SX80)" (P108 – P111) or "Projecting Data on USB Flash Memory (SX80)" (P112 – P118).
Image an Projecting
2 The selection is toggled through available input signal types by pressing the INPUT button.
•You can select the target input signal with [<] / [<].
•Only the input signals displayed in white can be selected.
3 Press the OK button to determine the input signal type.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
53