IP Router - Release 1.8 5-7
Profile Directory:Remote Profile
Remote (WAN) Profile
WAN Network Updates
Routing information updates across the WAN will occur based on this selection. This field is
only available when IP (Protocol) is set to <Route> or when IPX (Protocol) is set to
<Optimize>. This field should be set to <Never> if the NAT Gateway field, below, is set to
<Enabled>.
<Never> To prohibit all routing information updates. When this is selected, static routes
between the Router and the remote units must be configured.
<Periodic> Periodic updates across the WAN occur every 30 seconds for the IP protocol
and every 60 seconds for IPX.
<Triggered> Triggered updates occur only when changes within the network are detected.
This is the recommended setting.
GRE Tunnel
Use this field to define IP Tunneling for GRE (Generic Route Encapsulation). If enabled, define
the local and remote IP Tunnel Addresses, as well as the Secured GRE Tunneled Data. This
field is only available if the IP protocol is set to <Route>.
<All> Tunnel all packets on this interface to the tunnel destination address.
<By Network> Tunnel packets based on their destination address by matching GRE
network entries.

NOTE: If the IP protocol is set to <By Network>, establish the remote

address in the Static Networks window.

<Disabled> Disable GRE tunneling.