INSTALLATION
When using a TOSLINK optical input or output jack, always use a
IMPORTANT: We strongly recommend that before you connect any loudspeakers to your amplifiers, you complete all needed connections and set up procedures to your Cinema 11 as outlined below. This will reduce the chance that a wrong connection or other error will produce a high volume audio output that might damage your speakers or other components.
Given the wide variety of components that can be connected to your Cinema 11, there are numerous ways in which your system can be assembled. To help you with this task, use the chart at the end of this manual to record the components connected to your unit, as well as which type of input (analog, coaxial, Toslink, etc) is used. Keep this chart for future reference.
There are many possible ways to connect a particular device. Use the diagrams on the following pages as a guideline. The information in this section contains some of the more common situations you might encounter in your system.
Always consult the owner's manuals that come with the components you are connecting to the Cinema 11 for more information on the source component's connections.
CONNECTING A MULTI CHANNEL POWER AMPLIFIER
Before attempting to plug any jacks into any power amplifier, verify that the power amplifier is turned off and or disconnected from the AC mains. Failure to do so can potentially result in severe damage to your amplifier or loudspeakers.
Use the audio jacks labeled OUTPUT from the Cinema 11 to an external power amplifier such as the Cary Audio Cinema 7B Power Amplifier. The Cinema 11 can output up to 7.1 channels of sound depending on source components and source material.
The output jacks supplied by the Cinema 11 are: Left Front, Center, Right Front, Left Surround, Right Surround, Left Surround Back, Right Surround Back, and Subwoofer. Be sure to verify that the correct outputs are connected to the appropriate input jacks (Left Front to Left Front, Right Surround Back to Right Surround Back, etc.)
When a powered subwoofer is used, connect the Subwoofer output jack to the Line Input jack on your subwoofer and follow any specific connection and or configuration, instructions supplied with the subwoofer. If your subwoofer is a passive speaker, connect the subwoofer output jack on the Cinema 11 to the input of the amplifier used to power the subwoofer, and then connect the subwoofer speaker itself to the subwoofers’ power amplifier.
SECOND ZONE (ZONE 2)
Use the L and R channel ZONE 2 AUDIO OUTPUT audio jacks to connect the Cinema 11 to the audio inputs of an external amplifier or other audio component in a second zone. The signal present will reflect the input selection of the Cinema 11. This may be adjusted using the Zone Menu or the ZONE button on the remote control. It may be seen using the VFD MENU.
22
