MANUAL SOUND SETUP
8.When you have finished adjusting the level for all the speakers in your system, select BACK to return to SETUP Menu.
9.Select BACK to return to the SETUP MENU, or press the SETUP button to EXIT the SETUP MENU.
To Set Channel Levels Using The Test Tone Function:
1.Select the TEST MODE ....... AUTO in the SET BALANCE menu.
When you select this function, the Cinema 11's Test tone automatically cycle every few seconds through all the speakers connected.
The unit cycles through the speakers in the following sequence:
FRONT LEFT > CENTER > FRONT RIGHT > SURROUND RIGHT > SURROUND BACK RIGHT > SURROUND BACK LEFT > SURROUND LEFT > SUBWOOFER
2. Use the | and | buttons to adjust the speaker level. |
You can adjust the selected channel level in 0.5dB steps across a range of
NOTE: Use the | and | buttons to adjust the speaker level. |
3.Select BACK to return to the SETUP MENU, or press the SETUP button to EXIT the SETUP MENU.
SET CROSSOVER POINTS
The LPF/HPF (Low Pass Filter/High Pass Filter) Crossover menus are used to independently set the internal High Pass filter of the Cinema 11 each of the speakers.
Setting the Speaker Crossover Points
In the Cinema 11, the Crossover Points can be selected in 10Hz increments within a 40Hz to 150Hz or Full range. Select the crossover point closest to the
Select the subwoofer crossover point equal to the lowest crossover point of the other speakers. In general, low frequencies will be redirected from the speakers with the highest crossover points to the speakers with the lowest crossover points.
NOTE: The following selected menus appear on the Cinema 11 Display.
SPEAKER
SET CROSSOVER POINTS
31
