Cary Audio Design Cinema 11 To set TRIGGERS, To set AUTO INPUT SEEK, To set RESTORE DEFAULT

SETUP MENU

To set TRIGGERS:
1.	Press the	button until TRIGGERS is selected.
	The OTHER/ TRIGGERS menu appears.
2.	Use the	and	buttons to select the zone of triggers.

If select the ZONE 1, a 12-volt trigger signal is output when zone 1 is turned on the Cinema 11.

If select the ZONE 2, a 12-volt trigger signal is output when zone 2 is turned on the Cinema 11.

If select the ZONE 1 & 2, a 12-volt trigger signal is output when cinema 11 is turned on.

To set AUTO INPUT SEEK:

1. Press the button until AUTO INPUT SEEK is selected.

The OTHER/ AUTO INPUT SEEK menu appears.

2. Use the and buttons to select the auto input detect on or off.

When you select ON, the Cinema 11 can auto detect input sources.

To set Late Mode for Dolby Digital:

1.	Press the	button until LATE is selected.
2.	Use the	and	buttons to select the LATE mode in Off, Half and Full.

Note: This option only operates with a Dolby Digital or Dolby Digital EX source and one of these modes is active. This option allows you to set the 50% of Dynamic Range Compression used when the Cinema 11 is placed into the LATE Half mode and set 100% of Dynamic Range Compression used when you select the LATE mode in Full. This mode can also be selected by pressing the LATE button on the remote control.

This mode of operation makes the softest sounds louder and the loudest sounds softer, reducing the overall dynamic range. You will notice that the vocal dialogue is easy to understand in this mode even when playing quietly.

To set RESTORE DEFAULT:

1. Press the button until RESTORE DEFAULT is selected.

2.Press ENTER to run the RESTORE DEFAULT.

NOTE: When the processor is reset, you will lose all settings. When you are finished with the reset, the display appears:

OTHER

Restore Default!

3. Press the button to select GOTO MAIN MENU and press the ENTER to return to the

OTHER menu, or press the SETUP button to exit the SETUP MENU.

44