MANUAL SOUND SETUP
SET BALANCE
This step adjusts the output level of each channel so that they are properly matched. This must be done to insure a correct presentation of
NOTE: If for any reason you are not sure that you can accomplish this calibration task or have any doubts as to how it should be done, please contact Cary Audio's technical support group BEFORE attempting this process
Set the meter to Slow response, "C" weighting, and to the 70 dB sensitivity scale. Position the meter at the approximate center of your listening position, at average ear height [approximately
NOTE: The following selected menus appear on the Cinema 11 Display.
SPEAKER
SET BALANCE
To set the channel levels for your system:
1.Press the SETUP button to enter the SETUP MENU. The SETUP MENU/SPEAKER appears.
2.Press the ENTER button to enter the SPEAKER menu.
3. Press the | button to select SET BALANCE menu. |
4.Press the ENTER button to enter the SET BALANCE menu. The SET BALANCE/TEST MODE.....Off menu appears.
A special test tone will be generated allowing you to measure the output of the speaker that's playing.
5. | Press the | button until FL (FRONT LEFT) is selected. | |
6. | Use the | and | buttons to adjust the speaker level. |
You can adjust the selected channel level in 0.5dB steps across a range of
7. Press the | button when you have finished making the FRONT LEFT level adjustment. |
Repeat steps 5 and 6 until you have completed setting the level for each speaker in your system. Set all the levels to 75dB.
30