ASSEMBLY INSTRUCTIONS (CONTINUED)
3.
4.
Insert the Spool onto the Spool′s Holder. |
|
|
Making sure the Spool's Welding Wire | Attach a Spool with the help of latch. | |
unwinds from the bottom (clockwise). |
|
|
5. |
|
|
Screw the Fixing Cover into the Threaded Shaft (11A).
Routing the Wire
Note: When installing wire of different size or composition, you will also need to change wire settings, set gun polarity, and, possibly, install gas cylinder. (See pages 18 to 20.)
Welding Wire | Spool |
Figure A
1.IMPORTANT: Securely hold onto the end of the Welding Wire and keep tension on it during the following steps. If this is not done the Welding Wire will spring backward, creating a tangled “bird’s nest” and resulting in wasted wire. (See Figure A.)
2.Hold the Welding Wire securely while you cut enough Wire off the end of the Spool to remove all bent and crimped Wire. Make sure the cut end has no burrs or sharp edges (cut again, if needed). (See Figure A.)
SKU 95424, 95629 | For technical questions, please call | Page 14 | |
Troubleshooting section at end of manual. | |||
|
|
