2-5
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
OL-8371-05
Chapter2 Installing the Ac cess Point
Deploying the Access Points on the Wireless Network
Deploying the Access Points on the Wireless Network
Prior to beginning the actual access point deployment, perform th es e tasks :
•Ensure that a site survey has been preformed.
•Ensure that your network infrastructure devices are operational and properly configured.
•For lightweight access points, perform these tasks:
–
Ensure that your controllers are connected to switch trunk ports.
–
Ensure that your switch is configured with untagged access ports for connecting your access
points.
–
Ensure that a DHCP server with Option 43 configured is reachable by your access points.
To deploy your access points, follow these steps:
Step1 Obtain the access point location map created during your building site survey.
Step2 Review the access point locations and identify the specific mounting methods required for each access
point location.
Step3 For each access point perform these steps:
a. For lightweight access points, record the access point MAC address on the access point location
map. When you have completed the access point deployment, return the access point MA C addresses
and the access point locations on the access point loc ation m ap s or f l oor pl ans t o y our ne twor k
planner or manager. The network operators can use the MAC address and location inf orm ati on to
create maps for precise wireless system management.
b. Attach your access point to the mounting plate (see the “Attaching the Acc ess Point to the Mounting
Plate” section on page 2-16).
c. Mount the access point at the indicated destination using the sp eci fied mount ing me tho d. For
specific mounting instructions, see these sections:
–
Horizontal or vertical surface, such as a ceiling or wall (see the “Mounting on a Horizontal or
Vertical Surface” section on page2-9).
–
Below a suspended ceiling (see the “Mounting Below a Suspended Ceiling” section on
page 2-10).
–
Above a suspended ceiling (see the “Mounting Above a Suspended Ceiling” section on
page 2-11).
–
On a desktop or shelf (see the “Mounting Access Point on a Desktop or Shelf” section on
page 2-14.
d. Optionally secure the access point using a padlock or security cable (see the “Securing the Access
Point” section on page2-17).
e. Connect the access point cables (Ethernet, optional power, optional antennas). For instructions see
the “Connecting the Ethernet and Power Cables” section on page 2-20.
f. On power up, verify that the access point is associated to a controller and operating normally. For
additional information, refer to the “Checking the Lightweight Access Point LEDs” section on
page 3-2 or the “Checking the Lightweight Access Point LEDs” section on page 4-3.