Cisco Systems 1240AG manual Power Negotiation selected

Chapter 3 Troubleshooting 1240AG Series Autonomous Access Points

Low Power Condition

Configuring the Access Point System Power Settings Using a Browser

You can also use your browser to set the access point System Power Settings.

Note The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0 on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and Solaris platforms.

Note When using the access point browser interface, you should disable your browser pop-up blocker.

Figure 3-2shows the system power setting options and indicates the power status of the access point.

Figure 3-2 System Power Settings

Caution If the access point receives power through PoE, the output current of the power sourcing equipment (PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950 for limited power sources.

Table 3-3lists the access point system power settings and the Cisco switch power commands for several power options.

Table 3-3	Access Point System Power Settings and Cisco Switch Commands
			Cisco Switch
Power Source		Access Point System Power Settings	Power Command
AC power module		Configuration changes are not required	power inline never
Cisco switch that supports		Power Settings:	power inline auto
Intelligent Power Management1		Power Negotiation (selected)
		Power Injector:
		Installed on Port with MAC Address (unchecked)
Cisco switch that does not		Power Settings:	power inline auto
support Intelligent Power		Pre-standard Compatibility (selected)
Management1
		Power Injector:
		Installed on Port with MAC Address (unchecked)

Cisco Aironet 1240AG Series Access Point Hardware Installation Guide

OL-8371-05 3-11