
Chapter 2 Installing the Access Point
Attaching the Access Point to the Mounting Plate
To remove the cable security bracket from the mounting plate, follow these instructions:
Step 1 Position the mounting plate with the cable security bracket pointing down (see Figure
Step 2 Remove the two screws that attach the bracket to the mounting plate using a phillips screw driver.
Attaching the Access Point to the Mounting Plate
Follow these steps to attach the access point to the mounting plate:
Step 1 If your mounting plate has the cable security bracket, follow these steps:
a.Connect the Ethernet cable to the access point Ethernet port (see the “Connecting the Ethernet and Power Cables” section on page
b.If not using
c.Carefully feed the Ethernet and power cables through the cable notch on the cable security bracket and slide the cables to the right or left to secure the cables (see the “Cable Security Bracket” section on page
Note If your access point is connected to Ethernet
Step 2 Line up the four keyhole clips on the mounting plate with the large ends of the
Note The keyhole clips on each side of the mounting plate are offset and can only be positioned in one direction onto the access point.
Step 3 Insert the mounting plate clips into the keyhole shaped holes on the access point.
Step 4 Slide the access point towards the cable security bracket end of the mounting bracket while exerting slight pressure to force the access point and mounting plate together. You will hear a slight click when the locking detents contact the access point and locks it into place.
Step 5 Attach and adjust the antenna(s) or antenna cables to the access point antenna connectors.
Note The
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
|
| |
|